Jun 22, 2020

How Do You Use a Drill for Beginners?

Popular asked question about a drill. How do you use a drill for beginners? Can you use a power drill as a screwdriver? Can a 12v drill go through concrete?

Safety: Always remove the battery when using a cordless drill (or disconnect from power source if utilizing a corded drill) before exchanging drill bits.

  • Loosen the chuck to either remove, adjust or change out the drill bit.
  • Then insert the bit.
  • Proceed to tighten the chuck.
  • Then adjust torque.
  • Stabilize the drill vertically and start with a low speed and gradually speed up.

This is a short version on how do you use a drill for beginners? See the video below to have a better idea on this question.

How do you use a power drill as a screwdriver?

  • Ensure the drill is at slow speed.
  • Make sure that the head of your bit is in good condition since a worn bit is less likely to stay in the head of the screw.
  • When driving, keep pressing on the drill to keep the head of the bit in the screw and don’t take the pressure off as you approach the material you’re screwing into, keep it on and let the torque setting stop the drill at the right spot.
  • Don’t try to keep driving a screw where a bit has already slipped but pull it out and get a new one.

Did yo know: The first cordless drill was invented by Black & Decker in 1961

What do the symbols on a drill mean?

  • It automatically puts out the maximum amount of torque that the drill can maintain ignoring the torque settings. If the drill does not a mode selector then the highest torque setting is marked with the symbol of a drill

BLACK+DECKER Corded Drill, 5.2-Amp, 3/8-Inch (DR260C)
BLACK+DECKER Corded Drill, 5.2-Amp, 3/8-Inch (DR260C)

  • The numbers on a drill represent the amount of torque the tool can apply to an object (such as a screw) or for hole drilling. The numbers typically range from 1 to 20 (or more) with 1 representing the least amount of torque and 20, the greatest.


What is the hammer setting on a drill used for?

  • A hammer drill, also known as a percussion drill or impact drill, is a power tool utilized mainly for drilling in hard materials. It is a type of rotary drill with an impact mechanism that produces a hammering motion.


Can a 12v drill go through concrete?

  • Drilling a hole into concrete is best accomplished with a drill that you can plug into a wall outlet. But if you do not have a corded drill, or if the concrete is in a location where no electricity is available, you might have to complete the job with a 12 volt drill.


What’s the difference between a hammer drill and an impact drill?

  • A hammer drill exerts greater force directly into the bit as it hits the material being drilled, while an impact driver enhances the force being delivered perpendicular to the bit. That’s the direct force; it’s why a hammer drill can feel almost like a jackhammer when in your hands.


Can I use an impact driver to drill into concrete?

  • It is not recommended to utilize the impact drill for drilling the concrete. This is because of the solid density of concrete. For these tasks you will require either the hammer drill or you can also go with the best tool that should do this task for you. You can also select the rotary hammer drill.


What is the difference between an impact driver and a pulse driver?

  • A pulse tool will stop before damage is done, even if the operator is unaware of the danger while impact drivers are more likely to under-torque fasteners as well, as the operator could stop the tool prematurely in an attempt to prohibit exactly this type of damage.

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *